Some Industrial Buildings

Having laid the track in the t-gauge layout, we now need to start placing buildings on the industrial side. Because of the limited footprint available for our buildings, we need tall skinny buildings rather than low flat constructions. We also test a crane (though the prototype shown is vastly overscaled for t-gauge)! Once rough placed around the layout (and it is always important to do such a 'dry-run'), the buildings are fixed on place using multi-purpose glue and Isopon (car body filler).


As ever, these are prototype buildings. We've since refined the CG models and done 3D reprints. The boat house shown here is a case in point - much too low and narrow to work as a proper boat construction house! For this first layout, the test prints work fine. We'll bed them in and then paint them up with various rusts, washes and highlights.

Next, we start biting the bullet on the agricultural side of the layout. How will we get trees, hedges and fields done?

https://youtu.be/1nN148NKjiE

Comments

Post a Comment

Popular posts from this blog

Finally, a finished crazyTgauge layout - June 2022

Image
Finally, the first crazyTgauge layout is finished enough to do a 'launch' video! I could concentrate on all the obvious faults, in the layout and in the video, but I'll enjoy this moment instead! Two Hankyu motor units happily cruising through abandoned industrial workings and a rural landscape, as the sun sets on another Tgauge day! Only question now is 'what will the next crazyTgauge layout be'? I'll do a talkthrough video of this layout sometime over the next few weeks, with some updates on what was learned as the layout was finished. Hope you enjoy! Setting the tgauge track up to run the train units successfully was quite an education. After all the layout painting and flocking over the past few months, the track surface had to be rubbed down with wet and dry paper, then cleaned with alcohol wipes and finally 'reenergised' using the patented tgauge track pen. After that, the Hankyu units flew smoothly around, even allowing me to turn down the speed t
Read more

crazyTgauge

Image
Christmas is always a dangerous time! Last Christmas, I became fixated on a relatively new model railway gauge, called 't-gauge', the smallest working model railway gauge in the world! The track rails are only 3mm across and the scale is around 1:450, but the trains have real wheels, tiny electric motors and microscopic couplings! The trains, tracks and many accessories are produced by Eichindo in Japan. The attraction is that you could build a model railway layout in a very tiny space - let's face it, no-one has enough space for anything more in their house! A tiny, fully functioning model layout? The penny-pincher in me also thought a smaller layout would mean less materials used? A smaller layout would mean a quicker build? I'd also be able to test my 3D printing abilities, printing bridges and buildings for my layout? t-gauge.com in Edinburgh are the global distributors for these trains and their excellent website is a feast of locomotives, rolling stock, tracks, se
Read more

Test Running a t-gauge train on the layout

Image
This time, we test run a Hankyu t-gauge motor unit on the roughed out layout. We also fix some problems with bridges and tunnels. T-gauge tunnels need ready access from above, to reach derailed or stopped trains and (most importantly) to clean the track. With an impossibly small scale of 1:450, even small flecks of dust can stop your train dead! A couple of problems were identified with my layout's 3D printed bridges. The rail arches of the larger bridge, loosely based on the Clifton Suspension Bridge, turned out to be too low for the trains to pass through. The miscalculation was based on the fact that I'd forgotten that the raised eichindo trackbed is around 1.5 mm tall! This comedy error was quickly rectified and the 3D bridge model was fixed for future printing. The layout's smaller 3D printed bridges posed a slightly different problem - once assembled, they were just too narrow to admit the eichindo trackbed. Again, a simple problem, easily fixed in the 3D model. As ma
Read more